Steps for Toyota Corolla 2008 Remote Key Programming

Here is the steps for Toyota Vios / Corolla 2008 year remote key programming:
Before starting, you should check following status in advance:
1. Insert the key into the ignition
2. Only open the driver's door

Operate as follows, choose the module you want.
1. Insert the key into the ignition and pull out 2 times within 5 seconds.
2. Close and open the driver's door for 2 times (End with opening), then insert the key into the ignition and pull it out.
3. Close and open the driver's door for 2 times (end with opening), insert the key into the ignition and close the car doors.
4. Turn the ignition LOCK-ON-LOCK for one time, and then pull out the key from ignition.
5. At this time, the ECU will automatically lock and unlock the door within 5 seconds.
6. Within 40 seconds, on the original car remote controller press the "lock" and "unlock" button for 1-1.5 seconds at the same time, then get your hand off, finally press any of the two buttons for 1 second.
7. Within 5 seconds after you get your hand off, if successfully register it will automatically operate "lock" and "unlock" for one time; if fail to register it will automatically execute 2 times "lock" and "unlock" operation.
8. On the new car remote controller press the "lock" and "unlock" button for 1-1.5 seconds at the same time, then off your hand, followed is to press any of the two buttons over 1 second, within 5 seconds after you off your hand, if successfully register it will automatically operate "lock" and "unlock" for one time.

More related powerful Auto Key Programmers are listed below:
SKP-900 V3.2 Hand-Held Key Programmer:
http://www.obdexpress.co.uk/wholesale/superobd-skp-900-skp900-obd2-auto-key-programmer.html
The Key Pro M8:
http://www.obdexpress.co.uk/wholesale/car-key-programmer/